Здравстуйте,!!!
Долго я маялся с этой картой, в результате выяснил что она должна поддерживаться ядром.
вот какая информация поступила с сайта linuxtv:
Twinhan VP-1025
From LinuxTVWiki
Sold with trade name: TwinhanDTV Sat-Express
This low-profile-card is equipped with the Conexant Bt8xx PCI bridge and uses the bttv driver.
Well suppported by LinuxTV drivers.
Modules:
> modprobe bttv i2c_hw=1 card=0x71
> modprobe dst
> modprobe dvb-bt8xx
Here is a scan of the card:
Twinhan VP-1025
Twinhan VP-1025
Footnote
It has been suggested by linuxtv developer that the following source code change does not help please be advised.
With the recent kernel drivers the DST front end may fail to load. Kernel 2.6.17 for example. In the source edit drivers/media/dvb/bt8xx/dst.c at about line 89. In the function "int dst_gpio_outb" look for udelay(1000). Change that to msleep(200). Compile and install the modules and your 1025 will work just fine.
This problem is resolved in more recent kernel versions. Kernel 2.6.22 for example works perfectly.
If you are having trouble using your card, in particular if the drivers load without errors but the device files (/dev/dvb/*) don't get created, (or they could be created but the card doesn't work anyway) cold booting the system could resolve your problem, on some motherboards, the card doesn't reinitialize properly on reboot, so turning off the system completly may be needed to get the card to work
Может я и чайник и ничего понять не смог, поэтому пошел и купил SkyStar2, проблемы решились за две минуты.....
Можно было бы сказать что тема закрыта..., но ведь гложит самолюбие... и карта на полке лежит без дела...
Что с этой картой делать, и как ее все таки настроить под линукс...
?